Support
- Total activity 5344
- Last activity
- Member since
- Following 0 users
- Followed by 2 users
- Votes 0
- Subscriptions 5080
Articles
Recent activity by Support-
What are the contact details for UK and Ireland queries?
To write to us:Address:Stanley Black & Decker270 Bath RoadSloughBerkshireSL1 4DXTelephone: 01753 511234To send us an online query, you can complete the form found by clicking the ‘Contact Us’ link ...
-
Where can I get a drawing and parts list for my tool?
Drawings and Parts Lists are available on-line. Please click here to view drawings on Stanley products for the UK or here to view drawings for the Republic of Ireland. You will need to search for y...
-
Where can my product be repaired under warranty, within the UK?
Your product can be repaired at one of our service centres. Please remember to take a copy of your proof of purchase (e.g. till receipt, invoice) with you. If proof of purchase is unavailable, a ba...
-
How can I remove the chuck from my drill?
Firstly check to see if the chuck is secured with a screw, if you have a screw follow steps 1-3. If the chuck is not secured with a screw just follow steps 2-3.Step 1: Screw will have a left-hand t...
-
How many amps does a diesel engine need to start?
For diesel engines, you need: 250 to 400 amps for a 4 cylinder. 400 to 500 amps for a 6 cylinder. 500 to 700 amps for an 8 cylinder.
-
42-087 - Calibration specifications
The maximum angular derivation is +/- .10° The deviation in the calibration report reported below is .05°, which is well within that +/- .10° specification.
-
Spirit/Basic I-Beam levels accuracy
The accuracy specifications for these levels are shown below: Product Family Pin No. Primary Utile Surface Secondary Utile Surface Specific Notes Stanley Basic I-Beam Level STHT...
-
What is Argon?
Argon (Ar) is an inert gas, produced by the fractional distillation of the atmosphere. It is a gas extracted from the air that can contain traces of impurities such as oxygen, nitrogen or water vap...
-
How does the ammeter of the battery charger work?
The current you read on the ammeter is supplied to the battery by the charger. If you have connected it with an empty battery, it will deliver its maximum output, example 4 A. When charging, it bec...
-
My Lithium Booster’s display will not turn on, what should I do?
Make sure the unit is charged. Connect to a power source, to reset. Make sure the ON/OFF switch is set to the ON position.