The inches in diameter by 64ths scale is designed specifically for measuring diameters such as pipes. When you hold the tape around a pipe at the line which is ~1.5" from the hook (on the backside of the blade), then measure where it overlaps. That point is the diameter.
Articles in this section
- Where can I find information on the Stanley 49 bit gauge?
- When was my 2358 Mitre Box Manufactured?
- 19-614 and 19-114 (H114A) Mitre Box Instruction Guide
- How do I read the inches in diameter by 64ths scale on the 33-115?
- Where can I find instructions on the STANLEY PHT250C tacker?
- Where can I get a broken Stanley hand tool replaced?
- Can Stanley custom make hand tools?
- Where can I find information on Russell Jennings auger bits?
- Doweling Jig No. 59 Instructions
- How do I Assemble the Screwdriver Rack?